Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Initial Status
08-05-2016, 02:48 PM
Post: #1
Initial Status
Hello everyone!

It has been a long while since I have posted in the forums, so I thought I would post an update on what I've been doing in my spare time over the past few months or so..

When FleaFPGA Uno enquiries fell far short of the minimum needed to do another production run, I began designing a new FPGA development board. I was somewhat inspired by a product that had appeared in the marketplace around the same time as my Uno board. That board was the raspberry pi zero!

I then decided that I wanted to do an all-FPGA variant that was compatible to the pi in terms of GPIO but with 'a few extras here and there'. I then saw Lattice Semiconductor's newest ECP5 series FPGA (and far more capable than the MachXO2) became available recently, so I thought what the hey and had a crack at it.. Smile

Long story short: I created two new FPGA prototype boards using the capable ECP5 FPGA, which I've called the "Ohm" and "Ohm+".

Early prototype:
[Image: Flea_Ohm.jpg]

Related Video

Final prototype pics not yet released, but will include the following specs:
- 32MB 16-bit wide SDRAM (or 128MB LPDDR for Ohm+).
- microSD card slot
- Combined USB + PS/2 host port and USB slave serial port
- Digital video out
- 35 User GPIO pins, including four ADC channels
- Raspberry Pi compatible 40-pin GPIO header
- ESP-01 wifi module compatible 'Auxiliary' header
- On-board JTAG interface AND provision for an external JTAG
debugging pod are included.

I hope to receive my final PCB prototypes within the next two weeks or so.. More to follow - thanks for reading! Wink

Find all posts by this user
Quote this message in a reply
08-18-2016, 11:29 PM
Post: #2
RE: Initial Status
Hey Valentin, very cool fpga board!

You can count me in for a FleaFPGA Ohm+ as soon as they are ready Smile
Find all posts by this user
Quote this message in a reply
10-25-2016, 05:25 AM (This post was last modified: 10-26-2016 01:51 AM by Matej.)
Post: #3
RE: Initial Status
Very cute! Is possible to run Atari 800XL or other cores on it?
Ohm is beautiful!!! I love small boards.
Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)

Contact Us | Your Website | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication